Using Hardware
6
6.1
6.2
Using Hardware
This EVB consists of a MC33812 Small Engine Control Circuit, a USB to SPI Dongle interface, power
conditioning circuitry, and a set of Input Select Jumpers. All +5 volt VCC power required by the EVB is
obtained from the MC33812 built-in power regulator.
LED Display
Twelve LED’s are provided as visual output devices for the MC33812 EVB board. A list of the LED
devices is shown below:
1. VPWR LED - Indicates when +12V supply is connected to the EVB.
2. VCC LED - Indicates that the MC33812 internal +5V regulator is running and providing the +5V VCC voltage supply
3. IGNITION LED - Indicates that the Ignition Input, IGNIN, is active and the Ignition Output driver is turned on.
4. LAMP LED - Indicates that the Lamp Input, LAMPIN, is active and the Lamp Output is pulled low.
5. INJECTOR LED - Indicates that the Injector Input, INJIN, is active and the Injector Output is pulled low.
6. RELAY LED - Indicates that the Relay Input, RIN, is active and the Relay Output is pulled low.
7. RESET LED - Indicates that the RESETB output logic level is active (low).
8. INJECTOR FAULT LED - Indicates that there is either a short to Battery, Open Load or other fault on the Injector output.
9. RELAY FAULT LED - Indicates that there is either a short to Battery, Open Load or other fault on the Relay output.
10. IGNITION FAULT LED - Indicates that there is either a short to Battery, Open Load or other fault on the Ignition IGBT output.
11. MRX STATE LED - Indicates the state of the MRX line as a result of the data on the ISO9141 line.
12. USB ON LED - Indicates that the USB SPI dongle is connected properly and is attached to an active USB port on a PC.
Selection Jumper Definitions
The EVB contains four jumpers that provide certain selections for the MC33812 as follows ( Bold = default
factory setting):
6.2.1
JUMPER NAME
WD_INH
WDRFSH
LIN_PWR
IGNITION SUPPLY
WD_INH Jumper
JUMPER POSITION
1-2 / 2-3
OFF/ON
OFF/ON
1 -2 /2 - 3
/ CONNECTION
+5V PU/GND
OPEN/CNTL0
FLOAT/VPWR
VCC/VPWR
The WD_INH is the Watch Dog Inhibit enable/disable setting jumper. With a shorting jumper between pins
1 and 2, the WD_INH pin on the MC33812 is pulled high through a 4.7K resistor to +5 V, causing the
Watch Dog circuit to be disabled. With the shorting jumper between pins 2 and 3, or left off, the WD_INH
pin on the MC33812 is pulled to GND, enabling the Watch Dog circuit.
Freescale Semiconductor
7
相关PDF资料
KIT33879AEKEVBE BOARD EVALUATION FOR MC33879
KIT33880DWBEVB KIT EVAL FOR MC33880 8X SW W/SPI
KIT33886DHEVB KIT EVAL FOR MC33886 H-BRIDGE
KIT33887EKEVBE BOARD EVALUATION FOR MC33887
KIT33887PNBEVB KIT EVAL 33887 5A H-BRIDGE PQFN
KIT33905D5EKEVBE KIT EVALUATION FOR MC33905
KIT33912EVME KIT EVALUATION FOR MC33912
KIT33932VWEVBE KIT EVALUATION FOR MC33932
相关代理商/技术参数
KIT33813AEEVBE 功能描述:电源管理IC开发工具 2 Cylinder Small Engine RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V
KIT33814AEEVBE 功能描述:交换机 IC 开发工具 2 Cylinder Small Engine RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:USB Power Switches 工具用于评估:MAX4984E 工作电源电压:2.8 V to 5.5 V
KIT33816AEEVM 功能描述:电源管理IC开发工具 Engine Control Module RoHS:否 制造商:Freescale Semiconductor 产品: 类型: 工具用于评估: 输入电压: 输出电压:
KIT33879AEKEVBE 功能描述:电源管理IC开发工具 CONFIGURABLE OCTAL RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V
KIT33880DWBEVB 功能描述:电源管理IC开发工具 33880DWB COSS KIT RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V
KIT33883DWEVB 功能描述:KIT EVAL FOR MC33883 PRE-DRIVER RoHS:否 类别:编程器,开发系统 >> 过时/停产零件编号 系列:- 标准包装:1 系列:- 传感器类型:CMOS 成像,彩色(RGB) 传感范围:WVGA 接口:I²C 灵敏度:60 fps 电源电压:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相关产品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP
KIT33886DHEVB 功能描述:电源管理IC开发工具 33886 PWR H-BRIDGE KIT RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V
KIT33887DWBEVB 功能描述:电源管理IC开发工具 33887DWB FIESTA EVAL KIT RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V